AEG SCS51800S1, User Manual

Page: 5 / 84

• The appliance must not be located
close to radiators or cookers.
• Make sure that the mains plug is ac-
cessible after the installation of the ap-
pliance.
• Connect to potable water supply only
(If a water connection is foreseen).
1.6 Service
• Any electrical work required to do the
servicing of the appliance should be
carried out by a qualified electrician or
competent person.
• This product must be serviced by an
authorized Service Centre, and only
genuine spare parts must be used.
1.7 Environment Protection
This appliance does not contain
gasses which could damage the
ozone layer, in either its refriger-
ant circuit or insulation materials.
The appliance shall not be dis-
carded together with the urban
refuse and rubbish. The insula-
tion foam contains flammable
gases: the appliance shall be dis-
posed according to the applica-
ble regulations to obtain from
your local authorities. Avoid
damaging the cooling unit, espe-
cially at the rear near the heat ex-
changer. The materials used on
this appliance marked by the
symbol
are recyclable.
2. OPERATION
2.1 Switching on
Insert the plug into the wall socket.
Turn the Temperature regulator clock-
wise to a medium setting.
2.2 Switching off
To turn off the appliance, turn the Tem-
perature regulator to the "O" position.
2.3 Temperature regulation
The temperature is automatically regula-
ted.
To operate the appliance, proceed as
follows:
• turn the Temperature regulator to-
ward lower settings to obtain the mini-
mum coldness.
• turn the Temperature regulator to-
ward higher settings to obtain the
maximum coldness.
A medium setting is generally
the most suitable.
However, the exact setting should be
chosen keeping in mind that the temper-
ature inside the appliance depends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
If the ambient temperature is
high or the appliance is fully loa-
ded, and the appliance is set to
the lowest temperatures, it may
run continuously causing frost to
form on the rear wall. In this case
the dial must be set to a higher
temperature to allow automatic
defrosting and therefore reduced
energy consumption.
ENGLISH
5