Problem
Possible cause
Solution
Products prevent that wa-
ter flows into the water
collector.
Make sure that products
do not touch the rear
plate.
Water flows on the
ground.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
Attach the melting water
outlet to the evaporative
tray.
The temperature in
the appliance is too
low/high.
The temperature regula-
tor is not set correctly.
Set a higher/lower temper-
ature.
The temperature in
the refrigerator is
too high.
There is no cold air circu-
lation in the appliance.
Make sure that there is
cold air circulation in the
appliance.
The temperature in
the freezer is too
high.
Products are too near to
each other.
Store products so that
there is cold air circulation.
There is too much
frost.
Food is not wrapped cor-
rectly.
Wrap the food correctly.
The door is not closed
correctly.
Refer to "Closing the
door".
The temperature regula-
tor is not set correctly.
Set a higher temperature.
6.1
Replacing the lamp
CAUTION!
Disconnect the plug from the
mains socket.
1
1
2
1.
At the same time, with the fingers ex-
pand up and down the transparent
cover and unhook it in the direction of
the arrows.
2.
Replace the lamp with one of the same
power and shape, specifically designed
for household appliances. (the maxi-
mum power is shown on the light bulb
cover).
3.
Reassemble the lamp cover.
4.
Connect the plug to the mains socket.
5.
Open the door. Make sure that the
light comes on.
6.2
Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer
to "Installation".
3.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
ENGLISH
11
