AEG SCB61811LS, User Manual

Page: 28 / 68

8.1 What to do if...
Problem Possible cause Solution
The appliance does not op-
erate. The appliance is switched
off. Switch on the appliance.
The mains plug is not con-
nected to the mains socket
correctly. Connect the mains plug to the
mains socket correctly.
There is no voltage in the
mains socket. Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
The lamp does not work. The lamp is in stand-by. Close and open the door.
The lamp is defective. Contact the nearest Author-
ised Service Centre.
The compressor operates
continually. Temperature is set incor-
rectly. Refer to "Operation".
Many food products were
put in at the same time. Wait few hours and then check
the temperature again.
The room temperature is
too high. Refer to climate class chart on
the rating plate.
Food products placed in
the appliance were too
warm. Allow food products to cool to
room temperature before stor-
ing.
The door is not closed cor-
rectly. Refer to "Closing the door".
The "Frostmatic function"
is switched on. Refer to "Frostmatic function".
There is too much frost and
ice. The door is not closed cor-
rectly or the gasket is de-
formed/dirty. Refer to "Closing the door".
Temperature is set incor-
rectly. Refer to "Operation" .
The compressor does not
start immediately after
pressing the "Frostmatic",
or after changing the tem-
perature. This is normal, no error has
occurred. The compressor starts after a
period of time.
Water flows inside the refrig-
erator. Food products prevent the
water to flow into the wa-
ter collector. Make sure that food products
do not touch the rear plate.
www.aeg.com 28