AEG S93880KMB0, User Manual

Page: 17 / 32

through a drain hole into a special container at the back of the appliance, over the motor
compressor, where it evaporates.
Periods of non-operation
When the water system is not use for a long period, turn off the water connection to the
refrigerator.
• A filter that has been in service shall not be exposed to temperatures below 0°C as crack-
ing of the filter body may occur due to freezing expansion.
• If the filter still is to be preserved for later reuse, suitable storage temperature will be
+5°C.
When the appliance is not in use for long periods, take the following precautions:
1.
disconnect the appliance from electricity supply
2. remove all food
3. clean the appliance and all accessories
4. leave the door/doors open to prevent unpleasant smells.
Before using the appliance again, rinse the system thoroughly by dispensing at least three
litres (5 pints) of water.
• If necessary, the system can be cleaned by using a sanitizing kit which can be ordered
through Electrolux Service Force Centre or through our website www.electrolux.com.
If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food
inside from spoiling in case of a power failure.
WHAT TO DO IF…
During operation of the appliance some smaller but annoying trouble can often occur,
which does not require calling a technician out. In the following chart information is given
about them to avoid unnecessary charges on service.
The operation of the appliance goes with certain sounds (compressor and circulating
sound). This not means a trouble, but a normal operation.
The appliance operates discontinuously, so the stopping of compressor does not mean be-
ing no current. That is why you must not touch the electrical parts of the appliance before
breaking the circuit.
Problem Possible cause Solution
The appliance is noisy. The appliance is not supported
properly.
Check if the appliance stands sta-
ble (all feet and wheels should be
on the floor). Refer to "Levelling".
Sound level is too high
during dispensing of wa -
ter.
The transport supporting tie of
the water system pressure pump
has not been removed.
Remove the tie. Refer to "Remov-
ing the transport support".
The buzzer sounds. The
Alarm icon flashing.
The door is not closed correctly. Refer to "Door open alarm".
What to do if… 17