AEG S53830CNW2, User Manual

Page: 31 / 76

Problem Possible cause Solution
The lamp does not work. The lamp is defective. Contact the nearest Author-
ised Service Centre.
The compressor operates
continually. Temperature is set incor-
rectly. Refer to "Operation" chapter.
Many food products were
put in at the same time. Wait some hours and then
check the temperature again.
The room temperature is
too high. Refer to climate class chart on
the rating plate.
Food products placed in
the appliance were too
warm. Allow food products to cool to
room temperature before stor-
ing.
The door is not closed cor-
rectly. Refer to "Closing the door".
The FROSTMATIC function
is switched on. Refer to "FROSTMATIC func-
tion".
There is too much frost and
ice. The door is not closed cor-
rectly or the gasket is de-
formed/dirty. Refer to "Closing the door".
The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature. This is normal, no error has
occurred. The compressor starts after a
period of time.
Water flows on the rear
plate of the refrigerator. During the automatic de-
frosting process, frost
melts on the rear plate. This is correct.
Water flows inside the refrig-
erator. The water outlet is clog-
ged. Clean the water outlet.
Food products prevent
that water flows into the
water collector. Make sure that food products
do not touch the rear plate.
Water flows on the floor. The melting water outlet is
not connected to the
evaporative tray above the
compressor. Attach the melting water out-
let to the evaporative tray.
Temperature cannot be set. The FROSTMATIC or
COOLMATIC function is
switched on. Switch off FROSTMATIC or
COOLMATIC manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FROSTMATIC
or COOLMATIC function".
ENGLISH 31