Problem
Possible cause
Solution
Products prevent that wa-
ter flows into the water
collector.
Make sure that products
do not touch the rear
plate.
Water flows on the
ground.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
Attach the melting water
outlet to the evaporative
tray.
The temperature in
the appliance is too
low.
The temperature regula-
tor is not set correctly.
Set a higher temperature.
The temperature in
the appliance is too
high.
The temperature regula-
tor is not set correctly.
Set a lower temperature.
The door is not closed
correctly.
Refer to "Closing the
door".
The product temperature
is too high.
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Many products are stored
at the same time.
Store less products at the
same time.
There is no cold air circu-
lation in the appliance.
Make sure that there is
cold air circulation in the
appliance.
7.1
Replacing the lamp
1
2
The appliance is equipped with a longlife
LED interior light.
1.
Disconnect the appliance.
2.
Push the movable part to unhook the
lamp cover (1).
3.
Remove the lamp cover (2).
4.
If needed replace the lamp with a
light of similar characteristic and pow-
er. It is suggested to use Osram PAR-
ATHOM SPECIAL T26 0.8 Watts.
5.
Install the lamp cover.
6.
Connect the appliance.
7.
Open the door. Make sure that the
lamp comes on.
7.2
Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer
to "Installation".
3.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
ENGLISH
25
