Door reversibility
To carry out the following operations, we suggest that this be made with another person
that will keep a firm hold on the doors of the appliance during the operations.
To change the opening direction of the door, do these steps:
1.
Remove the plug from the power socket.
2.
Tilt back the appliance carefully so that the compressor cannot touch the floor.
3.
Unscrew both adjustable feet.
4.
Unscrew the screws of the door bottom
hinge. Remove the hinge. Put over the
pin in the direction of the arrow.
5.
Unscrew and install the screw on the
opposite side.
6.
Install the hinge on the opposite side.
7.
Remove the door by pulling it down-
wards while keeping it slightly opened.
8.
Unscrew the upper door hinge, and
screw it in on the opposite side.
9.
Put the door back in its place.
10. Relocate the door holder pin in the door
hinge as per the figure.
11. Place the door holder pin in the door at
the bottom on the left side, and fix the
door hinge with the screw.
12. Screw both adjustable feet.
13. Raise the appliance in the upright position.
14. Remove and install the handle
1)
on the
opposite side.
15. Reposition, level the appliance, wait for
at least four hours and then connect it
to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the natural
fitting of the gasket.
1) If foreseen
Installation
17
