Problem
Possible cause
Solution
Water flows inside the re-
frigerator.
The water outlet is clog-
ged.
Clean the water outlet.
Food products prevent wa-
ter from flowing into the
water collector.
Make sure that food products
do not touch the rear plate.
Water flows on the floor.
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
Attach the melting water out-
let to the evaporative tray.
The temperature in the ap-
pliance is too low/too high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera-
ture.
The food products temper-
ature is too high.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Many food products were
stored at the same time.
Store less food products at the
same time.
Side panels of the appli-
ance are warm.
This is a normal state
caused by operation of the
heat exchanger.
Make sure that there is at least
30 mm of space between each
side of the appliance and the
surrounding furniture when
the ambient temperature ex-
ceeds 38°C.
There is too much con-
densed water on the rear
wall of the refrigerator.
Door was opened too fre-
quently.
Open the door only when nec-
essary.
Door was not closed com-
pletely.
Make sure the door is closed
completely.
Stored food was not wrap-
ped.
Wrap food in suitable packag-
ing before storing it in the ap-
pliance.
Door does not open easily.
You attempted to re-open
the door immediately after
closing.
Wait a few seconds between
closing and re-opening of the
door.
If the advice does not lead
to the desired result, contact
the nearest Authorised
Service Centre.
6.2
Replacing the lamp
The appliance is equipped
with a long-life LED interior
light.
It is strongly recommended
to use original spare parts
only.
ENGLISH
9
