AEG PNC916098652, User Manual

Page: 16 / 32

To activate or deactivate an option touch
the relevant button or a two button
combination.
its symbol appears on the display or the
led above the corresponding button
lights up.
8.7 Child lock option
The child lock can be set to prevent
children from playing with the appliance.
The child lock option locks all touch
buttons and the program dial (this option
does not lock the Aan/Uit button).
You can activate the child lock option:
• before you touch the
Start/Pauze
button - the appliance cannot start
• after you touch the Start/Pauze
button - programs and option
selection is unavailable.
Child lock option activation:
1. Turn the dryer on.
2. Select 1 of the available programs.
3. Touch and hold down 2 buttons at
the same time.
The symbol appears on the display.
4.
To deactivate the child lock, touch
the above buttons again until the
symbol disappears.
8.8 Starting a program
4
To start the program:
Touch the
Start/Pauze button.
The appliance starts and the LED above
the button stops flashing and stays on.
8.9 Program change
To change a program:
1. Push the Aan/Uit button to turn the
appliance off.
2. Push the Aan/Uit button again to turn
on the appliance.
3. Set a new program.
8.10
Programme end
Clean the filter and drain the
water container after each
drying cycle. (See chapter
CARE AND CLEANING.)
If the drying cycle is finished, the symbol
appears on the display. If the Zoemer
option is activated, the acoustic signal
sounds intermittently for 1 minute.
If you do not turn off the
appliance, the anti-crease
phase starts (not active with
all programmes). Flashing
symbol signals the execution
of the anti-crease phase.
Laundry can be removed
during this phase.
To remove the laundry:
1. Push the Aan/Uit button for 2
seconds to turn the appliance off.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
www.aeg.com 16