Unscrew the two plastic screws (4 - Fig. A) and fit them on the oppo-
site side (4 - Fig. B).
Remove the catch hook (5 - Fig. A) by inserting a screwdriver into the
upper hole and pushing downwards.
Remove plate (6) by inserting a screwdriver into the bottom hole and
pushing upwards (Fig. A).
Refit the catch hook (5) and plate (6) on the opposite sides (Fig. B).
Remove the door catch (7) and plate (8) as explained in paragraph 7.
Turn the door 180°.
Refit the door catch (7) and plate (8), reversing their position and
pressing firmly to engage the hook (Fig. B).
Fit the door onto the machine. Insert the top pin first, then the bot-
tom pin into the hinge (3- Fig. B); finally screw the hinge onto the
washing machine.
Check that the door is aligned with the appliance. To do this, loosen
screw (9 - Fig. B) by a couple of turns and re-tighten when alignment
is correct.
Fit the flexible end of the door catch (1 - Fig. B) into the location
provided in the door.
Fitting a door panel
The door of this machine has mouldings to allow fitting of a decorati-
ve panel (stainless steel sheet, laminated plastic, wood etc.) to match
with the existing kitchen units.
The dimensions of the panel must be as follows:
Width
588 mm
Height
588 mm
Maximum thickness
4 mm
To fit the panel, remove the moulding by unscrewing its fixing screws.
Position the panel, then refit the moulding, making sure that it comes
into contact with and firmly clamps the panel.
43
Installation
132998960.qxd 7/11/02 9:24 AM Pagina 43 (Nero/Process Black pellicola)
Summary of Contents for OKO-LAVAMAT BELLA2100
Page 45: ...45 ...
