Run wash cycle
27
End of wash cycle/Removing the washing
If RINSE HOLD was selected:
0
After a rinse hold, the water has to be pumped out:
– Either press the START/PAUSE button (the washing is spun in
accordance with the program which has just finished; the final spin
speed can be changed whilst the washing is being spun using the spin
speed button),
or
– turn the program selector to PUMP OUT and press the START/PAUSE
button (the water is pumped out without the washing being spun),
or
– turn the program selector to SPIN or SHORT SPIN and press the
START/PAUSE button (the washing is spun or spun gently).
After this program step has been completed the END lamp is
illuminated.
0
Open the door.
As soon as the DOOR display is green the door can be opened.
0
Turn the program selector to OFF.
0
Remove the washing.
0
After the program has finished, pull the detergent drawer out a little so
that it can dry. Leave the door ajar for a while. This helps to prevent
stagnant smells and to preserve the door seal.
0
Close the water tap.
0
We recommend you unplug the appliance and turn off the water
supply when the wash program has finished.
3
If the OVERDOSING display lights up it shows that too much washing
powder was used in the washing program which has just run. For this
reason an extra rinse was carried out. Check the dosage instructions of
the detergent manufacturers.
