Instructions for use
31
The washing machine
vibrates during opera-
tion or it is on an une-
ven surface.
The height-adjustable screw
feet are not correctly set.
Adjust in accordance with
the installation and connec-
tion instructions.
There is not much washing in
the drum (e.g. only one
dressing gown).
This does not impair the
function.
The water could not be com-
pletely pumped off before
spinning because the drain-
age hose is bent
or
the solution pump is blocked.
Check the laying of the
drainage hose and eliminate
the bend if necessary, or
clean the solution pump and,
if required, remove foreign
bodies from the pump hous-
ing.
The washing solution
of the main wash
froths up a lot.
Too much detergent was
probably used.
Meter the detergent exactly
in accordance with the man-
ufacturer's information.
Water runs out under
the washing machine.
The screw connection on the
intake hose is leaky.
Tighten the intake hose
screw connection.
The drainage hose is leaky.
Check the drainage hose and
replace it if necessary.
The washing solution pump
cover is not correctly closed.
Close cover correctly.
Washing stuck in the filling
door.
Stop the program, remove
washing from the door, start
a new program.
The emergency drain hose is
not properly shut off or it is
not water-tight.
Shut the emergency drain
hose off properly (see section
"Performing an Emergency
Drain"). Call your after-sales
service if the emergency
drain hose is not water-tight.
Conditioner not added,
compartment
w
for
care agent full of
water.
Softener insert in the com-
partment for care agent not
correctly attached or is
blocked.
Clean the detergent drawer
and firmly attach the sof-
tener insert.
Problem
Possible Cause
Remedy
