27
Installation Instructions
UK
Any electrical work required to install this
appliance should be carried out by a quali−
fied electrician or competent person.
Any plumbing work required to install this
appliance should be carried out by a quali−
fied plumber or competent person.
•
The dishwasher is delivered ready for connection,
i.e. with power supply cable, drain hose and inlet
hose with fitted filter and seal.
•
The installation should be carried out to connec−
tions provided in a neighboring cupboard (not di−
rectly behind the unit).
•
The regulations of the local water and electricity
companies must be complied with.
Water Supply Connections
•
The dishwasher must be plumbed into a cold water
supply.
•
The water pressure must be within the limits given
in the technical specifications. Your local Water Au−
thority will advise you on the average mains pres−
sure in your area.
•
A shut−off device with a
¾
" connection must be
provided on site.
•
The inlet hose has a filter to remove any impurities
from the water supply and a rubber seal. When fit−
ting ensure that the filter and seal are correctly po−
sitioned
.
No water must escape from the fitting after
the shut−off device has been opened.
Water outlet hose connection
•
Ensure the drain hose is not bent or squashed as the
could prevent or slow down the discharge of water.
•
The outlet hose should be connected to a water
outlet provided in a neighboring cupboard (not di−
rectly behind the unit).
•
The dishwasher is fitted with a device to prevent the
back flow of water, which allows the installation
height of the unit to be above the outlet height.
•
The highest point of the drain hose should never ex−
ceed the unit height.
153 0409 25 / 09.99
AEG
762
510
574
759
570
550
600
546