AEG NKE 102, Operating And Installation

Page: 17 / 56

5. Cleaning, care and maintenance
To keep the appliance in good condition, clean the air outlet grille with a vacuum cleaner.
Clean the surfaces when cold with a soft cloth and ordinary cleaning products.
Please read
Avoid abrasive or corrosive cleaning products.
Please read
Never spray cleaning products into the air slot.
6. What to do if...
... the appliance does not work or only works to a limited degree: Please observe the following information and check the
possible sources of faults given here.
6.1 Fault table
Fault Cause Remedy
Bluish smoke forms. This can occur during commissioning, caused by
dust, for example.
Thoroughly vent the room. The smell
will dissipate within a few minutes.
Appliance stops. Temperature limiter has responded. Grilles on
appliance are covered or blocked.
Remove the cover or dirt. The
appliance will then automatically
continue to operate.
»
If you cannot remedy the fault, contact your local contractor.
»
For better and faster help, give him the type plate number.
The type plate is located at the bottom of the r.h. side panel of the appliance.
17
Operation - for users and contractors