AEG LWR7316O4B, User Manual

Page: 30 / 56

The programme starts, the door is
locked. The display shows the indicator
.
The drain pump can operate
shortly before the appliance
fills water.
11.7 Starting a programme
with the Finish In option
1. Touch this repeatedly until the
display shows the desired time within
the programme should end. The
indicator comes on.
2. Touch the Start/Pause button.
The drum starts rotating to perform the
ProSense estimation, if foreseen in the
selected programme.
3. The appliance starts the countdown
to the end of the programme and the
programme will start at the right
moment for ending at the time set
through this option.
To change or cancel this
option:
1. Switch the appliance off by means of
the On/Off button.
2. Switch the appliance on again.
3. Set the programme again.
11.8 The ProSense load
detection
The programme duration in
the display is referred to a
medium/high load.
After setting a washing programme, the
icon lights up on the display if
the programme supports it.
After touching the Start/Pause
button, the ProSense starts the laundry
load detection:
1. The appliance detects the load in the
first 30 seconds: the indicator
flashes, the bars under the
icon move back and forth and the
drum rotates shortly.
2. When the drum stops rotating, the
display shows the new programme
duration, that could increase or
decrease, adjusted accordingly the
load detected, the number of bars
indicates the load in quarter (from 1
to 4, 4 bars in case of overload), the
maximum declared load indicator
comes on again. After further 30
seconds, the water filling starts.
In case of in case of
drum overload, the
maximum declared load
indicator comes on again
with the
indicator
blinking. In this case,
during these 30
seconds, it is possible to
pause the appliance and
remove the exceeding
garments.
Once removed the
exceeding garments,
touch the Start/Pause
button to start the
programme again. The
ProSense phase can be
repeated up to three
times (see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again depending
on the capacity of water
absorption of the fabrics.
The ProSense detection is
carried out with complete
washing programmes only
(no skipping phase
selected).
The ProSense is not
available with some
programmes, such as Wool/
Handwash, programmes
with short cycles and without
washing phase.
www.aeg.com 30