10.
DAILY USE
10.1
Start a programme
without delay start
1.
Prepare the laundry and load the
appliance.
CAUTION!
Make sure that when you
close the door, the
laundry does not get
caught between the
appliance door and the
rubber seal.
2.
Set the correct programme and
options for the type of load.
The display shows the programme
duration.
The drying time you see on
the display, when the cotton
programme is selected, is
related to the load of 5 kg
and standard conditions .
Real drying time will depend
on type of the load (quantity
and composition), the room
temperature and the
humidity of your laundry
after spin drying phase.
3.
Press the Start/Pauze touch button.
The programme starts.
10.2
Starting the programme
with delay start
1.
Set the correct programme and
options for the type of load.
2.
Press the delay start button again
and again until the display shows the
delay time you want to set.
You can delay the start
of a programme from a
minimum of 30 minutes
to a maximum of 20
hours.
3.
Press the Start/Pauze touchpad.
The display shows the countdown of the
delay start.
When the countdown is completed, the
programme starts.
10.3
Change a programme
1.
Turn the Programme knob to OFF
2.
Set the programme.
10.4
At the end of the
programme
When the programme is completed:
• The indicator flashes.
• An intermittent acoustic signal
operates (If the Buzzer function is on).
• The indicator Filter comes on.
• The Start/Pauze indicator is on.
The appliance continues to operate with
the crease guard phase for
approximately other 30 minutes.
The crease guard phase removes creases
from your laundry.
You can remove the laundry before the
crease guard phase is completed. We
recommend, for better results, that you
remove the laundry when the phase is
almost completed or completed.
When the crease guard phase is
completed:
• The indicator is on but does not
flash.
• Start/Pauze indicator goes off.
1.
Turn the Programme knob to OFF
2.
Open the appliance door.
3.
Remove the laundry.
4.
Close the appliance door.
Always clean the filter
when a programme is
completed.
10.5
Stand-by function
To decrease the energy consumption,
this function automatically deactivates
the appliance:
• After 5 minutes if you do not start the
programme.
• After 5 minutes from the end of the
programme.
ENGLISH
13
