9.5
Cleaning the control panel
and housing
Use a standard neutral soap detergent
to clean the control panel and housing.
Use a moist cloth to clean. Dry the
cleaned surfaces with a soft cloth.
CAUTION!
Do not use furniture cleaning
agents or cleaning agents which
can cause corrosion to clean the
appliance.
10.
TROUBLESHOOTING
10.1
Troubleshooting
Problem
1)
Possible cause
Remedy
The tumble
dryer does
not operate.
The tumble dryer is not con-
nected to mains supply.
Connect in at mains socket.
Check fuse in fuse box (domes-
tic installation).
The loading door is opened.
Close the loading door.
The Auto/Off button was not
pushed.
Push the Auto/Off button.
The Start/Pause button was not
pushed.
Push the Start/Pause button.
The appliance is in the standby
mode.
Push the Auto/Off button.
Unsatisfac-
tory drying
results.
Incorrect programme selection.
Do the selection of the applica-
ble programme.
2)
The filter is clogged.
Clean the filter.
3)
The Dry Plus function was in
minimum mode.
Change the Dry Plus function
to the moderate or maximum
mode.
The heat exchanger filters are
clogged.
Clean the heat exchanger fil-
ters.
3)
Too high volume of the load.
Obey the maximum load vol-
ume.
The airflow grill is clogged.
Clean the airflow grill in the
bottom of the appliance.
Dirt on the inner surface of the
drum.
Clean the inner surface of the
drum.
Too high water hardness.
Set applicable water hard-
ness
4)
.
The door
does not
close.
The filter not locked in the po-
sition.
Put the filter in the correct posi-
tion.
The laundry is locked between
the door and the seal.
Put the load correctly in the
drum.
20 www.aeg.com
