HINTS AND TIPS
ECOLOGICAL HINTS
• Do not use fabric softener to wash
and then dry. In the tumble dryer
laundry becomes soft automatically.
• Use the condensate as distilled wa-
ter, e.g. for steam ironing. If it is nec-
essary clean the condensate before
(e.g. with a coffee filter) to remove
possible small pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Use the load volumes which are
specified in the programmes chapter.
• Make sure that is good airflow in the
appliance installation position.
• Clean the primary filter after each
drying cycle.
• Clean the heat exchanger filters
when the applicable indicator comes
into the view on the control panel.
• Spin good the laundry before drying.
AVERAGE LAUNDRY WEIGHTS
bathrobe
1200 g
quilt cover
700 g
man’s work shirt
600 g
man’s pyjamas
500 g
sheet
500 g
tablecloth
250 g
man’s shirt
200 g
night dress
200 g
pillow case
200 g
towelling towel
200 g
blouse
100 g
ladies’ briefs
100 g
men’s underpants
100 g
napkin
100 g
tea cloth
100 g
WATER HARDNESS AND
CONDUCTIVITY
Water hardness can be different for dif-
ferent locations. Water hardness has an
effect on the water conductivity and the
operation of the conductivity sensor in
the appliance. If you know the value of
the water conductivity you can adjust
the sensor to dry with the better results.
To change the sensor conductivity:
1.
Turn the programme dial to availa-
ble programme.
2.
Push at the same time the Dry Plus
(Drogen Plus) and the Anticrease
(Anti-kreuk) buttons. Hold down
until one of the symbols go into
view on the display:
–
low conductivity <300
μS/cm
–
moderate conductivity
300-600 μS/cm
–
high conductivity >600
μS/cm
3.
Push the Start Pause button again
and again until you set necessary
level.
4.
To memorise the setting push at
the same time the Dry Plus (Drogen
Plus) and the Anticrease (Anti-
kreuk) buttons.
WATER CONTAINER FULL —
INDICATION
By default the indication LED is always
on. It comes into the view at the end of
the cycle or when the water container is
full. When you use an external equip-
ment to drain the container, the LED
can be off.
To activate or deactivate the indication:
1.
Turn the programme dial to availa-
ble programme.
2.
Push at the same time the Dry Plus
(Drogen Plus) and Buzzer (Zoemer)
buttons and hold down until you
see the correct setting:
46
