10.2
Adjustment of the
remaining laundry moisture
degree
To change the default degree of the
remaining moisture of the laundry:
1.
Turn on the appliance.
2.
Wait approximately 8 seconds.
3.
Select 1 of available programmes.
4.
Push at the same time and hold
down the
Anticrease
and
Time
Drying
buttons.
One of the symbols goes into the view
on the display:
- the maximum dry laundry
- the more dry laundry
- the standard dry laundry
5.
Push the
Start/Pause
button
again and again until you set
necessary degree.
6.
To memorise the setting, push at the
same time the
Anticrease
and
Time Drying
buttons for
approximately 2 seconds.
10.3
Deactivating the Tank
indicator
The water container indicator is by
default on. It starts to light at the end of
the drying cycle or during the cycle if the
water reservoir is full. If the draining kit is
installed the water container is drained
automatically and indicator can be
permanently off.
To deactivate the indicator:
1.
Turn on the appliance.
2.
Wait approximately 8 seconds.
3.
Select 1 of available programmes.
4.
Push at the same time and hold
down the
Anticrease
and
Delay Start
buttons.
One of 2 configurations is possible:
• the Tank indicator:
is on and
the symbol
goes into the
view - the water container
indicator is permanently
on
• the Tank indicator:
is off and
the symbol
goes into the
view - the water container
indicator is permanently
off
11.
CARE AND CLEANING
11.1
Cleaning the filter
At the end of each cycle the indicator
Filter
is on and you must clean the filter.
The filter collects the fluff.
The fluff occurs while the
cloths are dried in the
tumble dryer.
1.
Open the door. Pull the filter.
www.aeg.com
16
