AEG LAVATHERM 59880, User Manual

Page: 9 / 32

Changing door stop
WARNING!
Before changing the door stop, disconnect the mains plug.
1. Open loading door.
2. Unscrew hinge
A
from the front of the
appliance and take off the loading door.
3. Remove cover plates B . To do this, insert
a thin screwdriver into the slots as
shown in the illustration, push down -
wards slightly and pry out the cover
plates.
4. Use an appropriate tool and exert pressure to unfasten locking block
C
from the snap-
on fixture, take out and re-insert on the other side having rotated the block through
180°.
5. Unscrew hinge
A
from the loading door, rotate through 180°, re-insert on the opposite
side and screw down.
6. Re-insert cover plates B on the opposite site having first rotated them through 180°.
7. Unscrew cover plates D from the front
of the appliance, rotate through 180°,
screw on the opposite side.
8. Unscrew door lock E , push down slightly
and remove from the front of the appli -
ance.
9. Push snap-in button
F
in and down,
push cover down slightly and remove from front of the appliance.
10. Change door lock
E
over to the opposite side, screw down the door interlock.
11. On the other side, insert cover
F
and allow snap-in button to lock into place.
12. Insert loading door and hinges into recesses on the front of the appliance and screw
down.
Note regarding contact protection:
The appliance is only secure for operations again
once all plastic parts have been inserted.
Special accessories
•
Stacking kit
These intermediate installation kits can be used to arrange the dryer and a washing ma -
chine (60 cm wide, front loaded) as a space-saving washer/dryer stack. The washing ma -
chine is at the bottom and the dryer is at the top.
Read carefully the instructions supplied with the kit.
Available from your Service Force Centre or your specialist dealer
•
Draining kit
Installation kit for direct draining of the condensed water into a basin, siphon, gully, etc.
The water reservoir then no longer has to be drained, it must however remain in its in -
tended position in the machine.
C
B
B
A
A
E
E
D
D
F F
Installation 9