21
Washing cycle complete/Removing the washing
At the end of the cycle a long acoustic signal sounds 3 times (when the
SOUND setting is NORMAL or LOW) and the messages “Cycle ended”
and “Door openable” appear alternately in the display.
1.
Open the door and remove the washing.
2.
Turn the programme knob to OFF.
3.
Turn off the tap.
4.
After the wash, pull out the detergent dispenser drawer slightly to al-
low it to dry. Leave the door slightly open to air the inside of the wash-
ing machine.
If RINSE HOLD
or NIGHT CYCLE
was selected:
After a Rinse Hold or when a programme with NIGHT CYCLE has ended,
the START/PAUSE indicator flashes. “Cycle ended” and “Door locked”
appear alternately in the display.
The water must first be drained off:
–
Turn the programme knob to OFF, then to DRAIN and press the
START/PAUSE key (the water is drained without spinning),
or
–
or turn the programme knob to OFF and then to SPIN. Change the
spin speed if necessary and press the START/PAUSE key (the water is
drained and the washing spun).
Setup
The special functions that can be set under Setup remain permanently
stored independent of each washing cycle – even after the appliance
has been switched off or the mains plug has been removed from the
socket.
Memory 1, 2, 3
Programme combinations can be stored at programme knob positions
MEMORY 1, 2, 3 and can then be selected using the programme knob.
To do this the desired programme combination is first put together and
then stored.
