AEG L8FB786CBS, User Manual

Page: 27 / 48

In case a selection is not
possible, no indicator
comes on and an acoustic
signal sounds.
12.6 Starting a programme
Touch the Start/Pauze - Départ/Pause
button to start the programme.
The related indicator stops flashing and
stays on.
In the display, the indicator of the
operating phase starts flashing.
The programme starts, the door is
locked. The display shows the indicator
.
The drain pump can operate
shortly before the appliance
fills water.
12.7 Starting a programme
with the delay start
1. Touch the Startuitstel - Départ Différé
button repeatedly until the display
shows the desired delay time. The
indicator goes on.
2. Touch the Start/Pauze - Départ/
Pause button.
The appliance starts the countdown of
the delay start.
When the countdown is completed, the
programme starts.
The ProSense estimation
starts at the end of the
countdown.
Cancelling the delay start
after the countdown has
started
To cancel the delay start:
1. Touch the Start/Pauze - Départ/
Pause button to pause the appliance.
The related indicator flashes.
2. Touch the Startuitstel - Départ Différé
button repeatedly until the display
shows .
3. Touch the Start/Pauze - Départ/
Pause button again to start the
programme immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Start/Pauze - Départ/
Pause button to pause the appliance.
The related indicator flashes.
2. Touch the Startuitstel - Départ Différé
button repeatedly until the display
shows the desired delay time.
3. Touch the Start/Pauze - Départ/
Pause button again to start the new
countdown.
12.8 The ProSense load
detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Start/Pauze - Départ/
Pause button, the maximum declared
load indicator goes off, the indicator
flashes, the ProSense starts the laundry
load detection:
1. The appliance detects the load in the
first 30 seconds: the indicator and
the time dots flash, the drum rotates
shortly.
2. At the end of the load detection, the
indicator goes off and the time
dots stop flashing. The programme
duration will be adjusted accordingly
and could increase or decrease. After
further 30 seconds, the water filling
starts.
At the end of the load detection, in case
of drum overload, the indicator
is
flashing in the display:
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pauze - Départ/Pause
button to start the programme again. The
ProSense phase can be repeated up to
three times (see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
ENGLISH 27