After some minutes from
the end of the
programme, the energy
saving function
deactivates the appliance
automatically.
1. Remove the laundry from the
appliance.
2. Make sure that the drum is empty.
After drying phase, clean the
drum, the seal and the inside
of the door with a wet cloth.
14. DAILY USE - DRYING ONLY
WARNING!
Refer to Safety chapters.
This appliance is an
automatic washer dryer.
14.1 Preparation to drying
1. Press the Aan/Uit-Marche/Arrêt
button for some seconds to activate
the appliance.
With a drying-only
programme the display does
not show the maximum load
and the ProSense estimation
is deactivated.
2. Load the laundry one item at a time.
3. Turn the programme dial to the
programme suitable for the items to
dry.
4. Tap on the Modus-Mode button twice
to exclude washing and perform
drying only. The Drogen-Séchage
indicator is on. The indicators
and
appear on the display.
When drying a big amount of
laundry, to have good drying
performances, make sure
that the laundry itself is not
rolled up and that is
uniformly distributed in the
drum.
14.2 Drying - Automatic
levels
1. Tap on the Droogtegraad-Niveau
séchage button repeatedly until the
display shows the required dryness
level. The indicators in the display
illuminate accordingly:
a.
Iron dry: for cotton
items;
b.
Cupboard dry: for
cotton and synthetic items;
c.
Extra dry: for cotton
items.
The display shows the drying
programme duration.
To have a good drying by
using less energy and in a
shorter time, the appliance
does not let you set a too
low spin speed for the items
to be washed and dried.
2. Touch button Start/Pauze-Départ/
Pause to start the programme.
In the display the door locked
indicator goes on, the indicator of the
running phase starts flashing.
The display also shows the remaining
programme time.
14.3 Timed Drying
1. Tap on the button Tijd-Minuterie
repeatedly to set the desired time
value (see the "Timed drying" table
the "Programmes" chapter). The
drying level indicator goes off and the
indicator comes on.
Each time you tap on this button the time
value increases by 5 minutes. The
display shows the set new time value.
2. Touch the Start/Pauze-Départ/Pause
to start the programme.
In the display the door locked
indicator comes on and the indicator of
the running phase starts flashing.
The display also shows the remaining
programme time.
www.aeg.com
34
