AEG L7TEN62E, User Manual

Page: 24 / 40

The ProSense detection is
carried out with complete
washing programmes only
(no skipping phase
selected).
The ProSense is not
available with some
programmes, such as Wol/
Zijde, programmes with
short cycles and without
washing phase.
11.13 Opening the Lid when
the programme operates
CAUTION!
If the temperature and level
of the water in the drum are
too high, the
indicator
stays on and you cannot
open the lid.
To open the lid proceed as follows:
1. Press the button Aan/Uit for some
seconds to deactivate the appliance.
2. Wait for some minutes and then open
carefully the lid.
3. Close the lid.
4. Activate the appliance and set the
programme again.
11.14 Opening the Lid when
the delay start is active
While the delay start operates, the
appliance lid is locked.
To open the appliance lid:
1. Press button Start/Pauze.
The indicator goes off.
2. Open the appliance lid.
3. Close the lid and press button Start/
Pauze.
The delay start continues.
11.15 End of cycle
When the programme has finished, the
appliance stops automatically. The
acoustic signal operates (if it is active).
In the display comes on and the lid
locked indicator
goes off.
The indicator of Start/Pauze button goes
off.
1. Press button Aan/Uit to deactivate
the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
show the end of the last set
programme. Turn the
programme knob to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door ajar, to prevent mildew
and odours
11.16 Draining water out after
end of cycle
The washing programme is
completed, but there is water in the
drum :
The drum turns regularly to prevent the
creases in the laundry.
The lid lock indicator
is on. The lid
stays locked.
You must drain the water to open the lid:
1. If necessary, decrease the spin
speed.
2. Press the Start/Pauze button.
The appliance drains the water and
spins.
3. When the programme is completed
and the door lock indicator goes
off, you can open the door .
4. Press Aan/Uit some seconds to
deactivate the appliance.
The appliance drains and
spins automatically after
approximately18 hours.
11.17 AUTO Stand-by option
The AUTO Stand-by function
automatically deactivates the appliance
www.aeg.com 24