Problem
Possible solution
Make sure that you set the correct temperature.
Decrease the laundry load.
Too much foam in the
drum during the washing
cycle.
Reduce the quantity of detergent.
After the washing cycle,
there are some deter-
gent residues in the dis-
penser drawer.
Make sure that the flap is in the correct position (UP for pow-
der detergent - DOWN for liquid detergent).
Make sure you have used the detergent dispenser according
the indications given in this user manual.
After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes. Deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
13.3
Emergency door opening
In case of power failure or functioning
failure the appliance door remains
locked. The washing programme
continues when the power is restored. If
the door remains locked in case of
failure, it is possible to open it using the
emergency unlock function.
Before opening the door:
CAUTION!
Risk of burns! Make sure
that the water
temperature is not too
high and the laundry is not
hot. If necessary, wait until
they cool down.
CAUTION!
Risk of injury! Make sure
that the drum is not
rotating. If necessary, wait
until the drum stops
rotating.
Make sure that the water
level inside the drum is not
too high. If necessary,
proceed with an
emergency drain (refer to
«Emergency drain» in
«Care and cleaning»
chapter).
To open the door, proceed as follows:
1.
Press the On/Off button to switch the
appliance off.
2.
Disconnect the mains plug from the
mains socket.
3.
Open the filter flap.
4.
Keep the emergency unlock trigger
pulled downward and, at the same
time, open the appliance door.
5.
Take out the laundry and then close
the appliance door.
6.
Close the filter flap.
www.aeg.com
34
