AEG L75670WD, User Manual

Page: 4 / 36

side, where the appliance door can not be fully
opened.
•
Connect the mains plug to the mains socket only at
the end of the installation. Make sure that there is
access to the mains plug after the installation.
•
The ventilation openings in the base (if applicable)
must not be obstructed by a carpet.
•
Ensure you have good ventilation in the installation
room to avoid the back flow of gases into the room
from appliances burning other fuels, including open
fires.
•
Exhaust air must not be discharged into a flue which is
used for exhausting fumes from appliances burning
gas or other fuels (if applicable).
•
The operating water pressure (minimum and
maximum) must be between 0,5 bar (0,05 MPa) and 8
bar (0,8 MPa).
•
Obey the maximum load volume of 7 kg (refer to the
“Programme chart” chapter).
•
The appliance is to be connected to the water mains
using the new supplied hose-sets. Old hose sets must
not be reused.
•
If the supply cord is damaged, it must be replaced by
the manufacturer, its Authorised Service Centre or
similarly qualified persons in order to avoid a hazard.
•
Wipe away lint that has accumulated around the
appliance.
•
Items that have been soiled with substances such as
cooking oil, acetone, alcohol, petrol, kerosene, spot
removers, turpentine, waxes and wax removers should
be washed in hot water with an extra amount of
detergent before being dried in the wash dryer.
•
Do not use the appliance if industrial chemicals have
been used for cleaning.
•
Do not dry unwashed items in the wash dryer.
•
Items such as foam rubber (latex foam), shower caps,
waterproof textiles, rubber backed articles and clothes
www.aeg.com 4