• The display shows the
programme duration.
2.
If necessary, change the temperature
and the spin speed or add available
options. When you activate an
option, the indicator of the set
option comes on.
If you set something
incorrect, the display shows
the message
.
10.7
Starting a programme
without the Finish In option
Touch the button
Start/Pause
.
• The indicator of the button
Start/
Pause
stops to flash and stays on.
• The programme starts, the door
locks, the indicator
is on.
• The drain pump can operate for a
short time at the beginning of the
washing cycle.
After approximately 15
minutes from the start of the
programme:
• The appliance adjusts
automatically the
programme duration
agree with the laundry
load.
• The display shows the
new value.
10.8
Starting a programme
with the Finish In option
1.
Touch the button
Finish In
again and
again to choose the number of hours
in which you want the washing cycle
to be finished.
The display shows the number of hours
you set (e.g.
) and the indicator above
the button
Finish In
is on to show that his
option is active.
2.
Touch the button
Start/Pause
:
• The door is locked.
• The appliance starts the
countdown.
• When the countdown is
completed, the programme starts
automatically.
You can cancel or change
the set of the Finish In
option before you touch the
button
Start/Pause
. After
touching the button
Start/
Pause
you can only cancel
the Finish In option.
To cancel the Finish In option:
a.
Touch the button
Start/Pause
to
set the appliance to pause. The
indicator of button
Start/Pause
flashes.
b.
Touch the button
Finish In
until
the indicator above this button
goes off.
Touch the button
Start/Pause
again to start the programme
immediately.
10.9
Interrupting a
programme and changing the
options
You can change only some options
before they operate.
1.
Touch
Start/Pause
.
The indicator of this button flashes.
2.
Change the options. If you change
any option the Finish In option (if set)
will be disabled.
3.
Touch
Start/Pause
again.
The programme continues.
10.10
Cancelling a running
programme
1.
Press the button On/Off for some
seconds to cancel the programme
and to deactivate the appliance.
2.
Press the same button again to
activate the appliance. Now, you can
set a new washing programme.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
www.aeg.com
14
www.devicemanuals.eu/