11
However when the ice becomes very thick on the inner liner, complete
defrosting should be carried out as follows:
1.
Remove the frozen food from the freezer, wrap it in several layers of new-
spaper and put it in a very cool place.
2.
Switch off the appliance and pull out the plug or turn the temperature
selector to “0” OFF.
3.
Leave the freezer compartment door open.
4.
Turn the thermostat knob to the required setting and replace the plug in the
power socket.
Warning!
Never use metal tools to scrape off
the frost
Do not use a mechanical device or
any artificial means to speed up the
thawing process other than those
recommended by the manufacturer.
A temperature rise of the frozen food packs, during defrosting, may shor-
ten their safe storage life.
Switching off the appliance
To switch off the appliance, turn the temperature regulator to position "0"
or disconnect from the electricity supply.
If the appliance is not going to be used for an extended period:
1.
Remove all refrigerated and deep-frozen packages as well as ice trays.
2.
Remove the mains plug or switch off.
3.
Defrost freezer compartment and clean thoroughly (see section: “Cleaning
and Care”).
4.
Leave the door open to avoid the build up of odours.
18
Installation
Electrical Connection
Any electrical work required to install this appliance should be carried
out by a qualified electrician or competent person.
WARNING – THIS APPLIANCE MUST BE EARTHED
The manufacturer declines any liability should these safety measures not
be observed.
Before switching on, make sure the electricity supply voltage is the same as
that indicated on the appliance rating plate. The rating plate is inside, on the
left.
The appliance is supplied with a 13 amp plug fitted. In the event of having
to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362)
fuse must be used.
Important!
The wires in the mains lead are
coloured in accordance with the fol-
lowing code:
Green and Yellow Earth
Blue Neutral
Brown
Live
As the colours of the wires in the
mains lead of this appliance may not
correspond with the coloured mark-
ings identifying the terminals in your
plug, proceed as follows:
1.
The wire coloured green and yellow must be connected to the terminal
marked with the letter “E” or by the earth symbol or coloured green and yel-
low.
2.
The wire coloured blue must be connected to the terminal marked “N” or
coloured black.
3.
The wire coloured brown must be connected to the terminal marked “L” or
coloured red.
4.
Upon completion there must be no cut, or stray strands of wire present and
the cord clamp must be secure over the outer sheath.
Warning!
A cut-off plug inserted into a 13 amp socket is a serious safety
(shock) hazard. Ensure that the cut-off plug is disposed of safely.
D207
GREEN & YELLOW
13 AMP. FUSE
BROWN
CORD CLAMP
BLUE
13 AMP
