AEG GB 5687, Instruction Manual, Page: 27 / 46

English
27
GB5687_AEG_IM 03.01.17
Overview of the Components
1 Display
2 Button (Reduce temperature)
3 Button (Increase temperature)
4 Button (On / Off)
Notes on Use
Use the appliance only for dry, combed hair.
Ionizing function with tourmaline coating –
Reduction of electrically-charged hair
The anti-static effect allows easier hair styling. The hair does
not dry out, it becomes smooth and sparkling.
Electrical Connection
You can connect the appliance to an outlet with a voltage
from 110 V AC to 240 V AC.
Automatic standby circuit
For safety reasons, the appliance will automatically switch to
standby after about 25 minutes without any operation. The
display shows
OFF .
Before Initial Use
1. Remove the appliance from its packaging.
2. Check the appliance for any transport damage to prevent
a hazard.
NOTE:
• There may still be dust or production residues on the
surface of the device. We recommend to clean the
appliance as described under “Cleaning”.
• When the device is switched on for the first time there
may be a slight smell. You should therefore operate the
device for approximately 10 minutes without smoothing
your hair. Ensuring sufficient ventilation!
Commissioning
1. Fully unwind the mains cable.
2. Insert the plug in a duly installed socket. The display
shows OFF .
3. Press and hold the button for 3 seconds to switch the
device on.
NOTE:
• The appliance always starts with the temperature
set to 190 °C.
• The display shows the current temperature.
• You can change the temperature indication from
°C to °F by pressing the buttons and at the
same time.
4. Select a temperature between 80 °C (176 °F) and 190 °C
(374 °F):
• With the button you can reduce the temperature by
5 °C each time.
• With the button you can increase the temperature
by 5 °C each time.
General Use
1. Wait until the display shows the desired temperature.
2. Hold one strand of hair tight.
3. Hold the brush so that the bris-
tles point away from the scalp.
4. Guide the brush slowly through
the strand of hair. Always begin
at the base of the hair and move
the device in the direction of the
hair tip.
5. Repeat the process for one
strand at a time.
Stop Operation
1. Press and hold the button for 3 seconds. The display
shows OFF .
2. Remove the mains plug.
3. Leave the device to cool before putting it away!
Therefore place the appliance onto a heat-resistant, level
surface.