Problem and alarm code
Possible cause and solution
The remaining time in the
display increases and skips
nearly to the end of program
time.
• This is not a defect. The appliance is working correctly.
Small leak from the appli-
ance door.
• The appliance is not levelled. Loosen or tighten the ad-
justable feet (if applicable).
• The appliance door is not centred on the tub. Adjust the
rear foot (if applicable).
The appliance door is diffi-
cult to close.
• The appliance is not levelled. Loosen or tighten the ad-
justable feet (if applicable).
• Parts of the tableware are protruding from the baskets.
Rattling/knocking sounds
from inside the appliance.
• The tableware is not properly arranged in the baskets.
Refer to basket loading leaflet.
• Make sure that the spray arms can rotate freely.
The appliance trips the cir-
cuit-beaker.
• The amperage is insufficient to supply simultaneously all
the appliances in use. Check the socket amperage and
the capacity of the meter or turn off one of the applian-
ces in use.
• Internal electrical fault of the appliance. Contact an Au-
thorised Service Centre.
Refer to
"Before first use"
,
"Daily use"
, or
"Hints and
tips"
for other possible
causes.
Once you have checked the appliance,
deactivate and activate the appliance. If
the problem occurs again, contact an
Authorised Service Centre.
For alarm codes not described in the
table, contact an Authorised Service
Centre.
12.1
The washing and drying results are not satisfactory
Problem
Possible cause and solution
Poor washing results.
• Refer to
"Daily use"
,
"Hints and tips"
and basket
loading leaflet.
• Use more intensive washing programmes.
• Clean spray arm jets and filter. Refer to
"Care and
Cleaning"
.
www.aeg.com
18
