AEG FAVORIT 99709 M0P, User Manual, Page: 20 / 24

Problem Possible solution
The appliance does not drain the
water.
The display shows the message:
Appliance is not draining water. • Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or
bends.
The anti-flood device is on.
The display shows the message:
Appliance is flooding or has an
error in the water inlet. • Close the water tap and contact an Authorised Serv-
ice Centre.
Once you have checked the appliance,
deactivate and activate the appliance. If
the problem occurs again, contact an
Authorised Service Centre.
For other alarm messages or problems
not described in the table, contact an
Authorised Service Centre.
12.1 The washing and drying results are not satisfactory
Problem Possible solution
There are whitish streaks or
bluish layers on glasses and
dishes. • The release quantity of rinse aid is too much. Adjust
the rinse aid selector to a lower position.
• The quantity of detergent is too much.
There are stains and dry water
drops on glasses and dishes. • The released quantity of rinse aid is not sufficient. Ad-
just the rinse aid selector to a higher position.
• The quality of the rinse aid can be the cause.
The dishes are wet. • The programme does not have a drying phase or has
a drying phase with low temperature.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
• The quality of the multi-tablets can be the cause. Try a
different brand or activate the rinse aid dispenser and
use rinse aid and multi-tablets together.
Refer to " Hints and tips " for
other possible causes.
13. TECHNICAL INFORMATION
Dimensions Width / height / depth (mm) 596 / 818-878 / 580
Electrical connection
1)
Voltage (V) 220 - 240
Frequency (Hz) 50
Water supply pressure bar (minimum and maximum) 0.5 - 8
MPa (minimum and maximum) 0.05 - 0.8
Water supply
Cold water or hot water
2)
max 60 °C
www.aeg.com 20