AEG FAVORIT 88040VI, User Manual, Page: 61 / 68

WHAT TO DO IF…
The appliance does not start or stops during operation.
First try to find a solution to the problem (refer to the chart). If not, contact the service
centre.
Malfunction Fault code Possible cause Possible solution
The appliance does
not fill with water.
The display
shows The water tap is
blocked or is furred
with limescale.
Clean the water tap.
The water pressure is
too low.
Contact your local wa -
ter authority.
The water tap is closed. Open the water tap.
The filter in the water
inlet hose is blocked.
Clean the filter.
The connection of the
water inlet hose is not
correct.
Make sure that the
connection is correct.
The water inlet hose is
damaged.
Make sure that the wa -
ter inlet hose has no
damages.
The appliance does
not drain the water.
The display
shows There is a blockage in
the sink spigot.
Clean the sink spigot.
The connection of the
water drain hose is
not correct.
Make sure that the
connection is correct.
The water drain hose
is damaged.
Make sure that the wa -
ter drain hose has no
damages.
The anti-flood device
operates.
The display
shows Close the water tap
and contact the serv -
ice centre.
The programme does
not start.
The appliance door is
open.
Close the door correct -
ly.
The mains plug is not
connected in.
Put in the mains plug.
Blow out fuse in the
household fuse box.
Replace the fuse.
The delay start is set. If you want to cancel
the delay start, refer
to 'Select and start a
washing programme'.
After the check, switch on the appliance. The programme continues from the point of
interruption.
What to do if… 61