AEG Favorit 87004, User Manual, Page: 18 / 24

Malfunction Fault code Possible cause Possible solution
The water pressure is
too low.
Contact your local wa -
ter authority.
The water tap is closed. Open the water tap.
The filter in the water
inlet hose is blocked.
Clean the filter.
The connection of the
water inlet hose is not
correct.
Make sure that the
connection is correct.
The water inlet hose is
damaged.
Make sure that the wa -
ter inlet hose has no
damages.
The appliance does not
drain the water.
• An audible signal
operates.
• The display shows
.
There is a blockage in
the sink spigot.
Clean the sink spigot.
The connection of the
water drain hose is not
correct.
Make sure that the
connection is correct.
The water drain hose is
damaged.
Make sure that the wa -
ter drain hose has no
damages.
The anti-flood device
operates.
• An audible signal
operates.
• The display shows
.
Close the water tap
and contact the serv -
ice centre.
The programme does
not start.
The appliance door is
open.
Close the door correct -
ly.
The mains plug is not
connected in.
Put in the mains plug.
Blow out fuse in the
household fuse box.
Replace the fuse.
The delay start is set. If you want to cancel
the delay start, refer to
'Select and start a
washing programme'.
After the check, switch on the appliance. The programme continues from the point of
interruption.
If the malfunction shows again, contact the service centre.
If the display shows other fault codes, contact the service centre.
The necessary data for the service centre is on the rating plate.
We recommend that you write the data here:
Model (MOD.) ....................
18 What to do if…