Operating Instructions
32
Switching off the dishwasher
When the wash programme has ended, a beam of light will display a
red dot on the floor beneath the appliance’s door. Do not open the
dishwasher door before this optical signal illuminates.
3
The spot-control light signal is not dangerous as it is not a laser light.
3
If the appliance has been installed higher up with a furniture door
mounted flush, the optical signal will no longer be visible.
If the acoustic signal has been enabled, a continuous tone will sound
for 15 seconds at the end of the dishwashing cycle.
1
Hot steam may escape if the door is opened immediately after the cycle
has ended. Therefore:
0
1.
Open the door carefully.
2.
Switch off the dishwasher by pressing the ON/OFF button.
All display indicators will go out.
If you do not switch off the dishwasher, the acoustic signal will sound
again 3 minutes later and 6 minutes later.
3
Removing the dishes
• Hot dishes are sensitive to knocks. The dishes should therefore be
allowed to cool before they are removed.
• Leave the dishes in the dishwasher for approximately 15 minutes fol-
lowing the end of the cycle to enable better drying and cooling down
of dishes.
• Empty the lower rack first, then the upper rack. This will avoid water
spots, which are caused by remaining water in the upper rack drip-
ping onto the dishes in the lower rack.
Care and Cleaning
1
Do not under any circumstances use furniture care products or aggres-
sive cleaners.
• If necessary, clean the controls only with a soft cloth and pure warm
water.
• Occasionally check the internal containers, door seal, and water inlet
for soiling, clean if necessary.
