Power consumption
Off-mode (W)
0.10
1)
Refer to the rating plate for other values.
2)
If the hot water comes from alternative source of energy, (e.g. solar panels, aeolian energy), use the
hot water supply to decrease energy consumption.
14.
INSTALLATION
14.1
Fitting under a counter
The plinth of a freestanding appliance is
not adjustable. Do not remove the work-
top if you want to use the appliance as a
freestanding unit.
It is not necessary to remove the work-
top when installing under a standard
kitchen counter. Only remove the work-
top when installing the appliance under a
close fitting sink unit or kitchen counter
(820 mm).
Put the appliance adjacent to a water tap
and a water drain.
Make sure that the dimensions of the
recess agree with the dimensions in the
picture.
min 570 mm
600 mm
820 mm
Removing the work-top
1.
Remove the rear screws (1).
1
2.
Pull the work-top from behind (2).
2
3.
Lift the work-top and move it from
the front slots (3/4).
4
3
4.
Level the appliance using the
adjustable feet.
5.
Install the appliance under the
kitchen counter.
Adjusting the level of the
appliance
A correct adjustment of the level of the
appliance allows the door to close and
seal correctly.
If the door does not close correctly,
loosen or tighten the adjustable feet to
level the appliance.
14.2
Water connection
Water inlet hose
Connect the inlet hose to a water tap
with an external BSP thread spout of
3/4''.
For best washing performance it is
recommended to connect the appliance
to a cold water supply.
Energy savings can be made by
connecting the appliance to a Solar
www.aeg.com
20