AEG FAVORIT 76672 M0P, User Manual, Page: 9 / 28

Programme
1)
Water
(l)
Energy
(kWh)
Duration
(min)
P5
GLASS 13 - 13.5 0.7 - 0.9 60 - 70
P6
30MIN 9 0.8 30
P7
PREWASH 4 0.1 14
P8
EXTRA SILENT 9.0 - 10.5 1.0 - 1.2 210 - 220
1)
The pressure and the temperature of the water, the variations of the mains supply, the options and the
quantity of dishes can change the values.
5.2 Information for test
institutes
For all the necessary information for test
performance, send an email to:
info.test@dishwasher-production.com
Write down the product number (PNC)
that is on the rating plate.
6. SETTINGS
6.1 Programme selection
mode and user mode
When the appliance is in programme
selection mode it is possible to set a
programme and to enter the user mode.
In user mode, the following settings
can be changed:
• The activation or the deactivation of
the acoustic signal for end of
programme.
• The level of rinse aid according to the
required dosage.
These settings will be saved until you
change them again.
How to set the programme
selection mode
The appliance is in programme selection
mode when the display shows the
programme number
P1
.
When you activate the appliance, usually
it is in programme selection mode.
However, if this does not happen, you
can set the programme selection mode
in the following way:
Press and hold simultaneously and
until the appliance is in programme
selection mode.
6.2 The rinse aid dispenser
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
You can set the released quantity of rinse
aid between level 1 (minimum quantity)
and level 6 (maximum quantity). Level 0
will deactivate the rinse aid dispenser
and no rinse aid will be released.
Factory setting: level 4.
How to set the rinse aid level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously
and until
the indicators , and start to
flash and the display is blank.
2. Press .
ENGLISH 9