28
What to do if...
Remedying small malfunctions
In the event of a fault, the light signal at floor level flashes.
If the acoustic signal is activated, warning tones sound if there are
faults.
If one of the following fault codes is displayed in the multi-display dur-
ing operation:
–
Fault code
Å 10
(Problems with water inlet),
–
Fault code
Å 20
(Problems with water drainage),
please have a look at the following table.
When the fault is remedied, press the button for the cycle that has
started. The cycle will continue.
With other fault codes (“
Å
” followed by a number):
–
Abort the dishwashing cycle.
–
Switch the appliance off and on again.
–
Re-set the dishwashing cycle.
If the fault is displayed again, please contact your local Service Force
Centre and inform them of the fault code.
Malfunction
Possible cause
Remedy
1 short warning tone
,
continuously repeated,
can be heard,
the cycle indicator for the
selected wash program is
flashing:
the control indicator
lights up:
fault code
Å 10
is dis-
played in the multi-dis-
play:
(Problems with water in-
let)
Water tap is blocked with
limescale or is faulty.
Check the tap and have it
repaired, if necessary.
The tap is turned off.
Turn on the tap.
The filter (where present) in
the threaded hose fitting
on the tap is blocked.
Clean the filter in the
threaded hose fitting.
Filters in the base of the
washing compartment are
blocked.
Cancel the dishwashing cy-
cle (see chapter: Starting a
dishwashing cycle),
clean filters (see chapter:
Cleaning the filters),
then start the dishwashing
cycle again.
Water supply hose has not
been correctly positioned.
Check the position of the
hose.