TROUBLESHOOTING
The appliance does not start or it stops
during operation.
First try to find a solution to the prob-
lem (refer to the table). If not, contact
Service.
With some problems, the display
shows an alarm code:
•
- The appliance does not fill with
water.
•
- The appliance does not drain
the water.
•
- The anti-flood device is on.
WARNING!
Deactivate the appliance before
you make the checks.
Problem
Possible cause
Possible solution
The programme
does not start.
The mains plug is not con-
nected in the mains socket.
Connect the mains plug.
The appliance door is open. Close the appliance door.
The fuse in the fuse box is
damaged.
Replace the fuse.
The delay start is set.
Cancel the delay start or
wait for the end of the
countdown.
The appliance does
not fill with water.
The water tap is closed.
Open the water tap.
The water pressure is too
low.
Contact your local water au-
thority.
The water tap is clogged or
there is limescale on it.
Clean the water tap.
The filter in the water inlet
hose is clogged.
Clean the filter.
The water inlet hose has a
kink or a bend.
Make sure that the position
of the hose is correct.
The anti-flood device is on.
There are water leakages in
the appliance.
Close the water tap and
contact Service.
The appliance does
not drain the water.
The sink spigot is clogged.
Clean the sink spigot.
The water drain hose has a
kink or a bend.
Make sure that the position
of the hose is correct.
After the checks are completed, acti-
vate the appliance. The programme
continues from the point of interrup-
tion.
If the problem occurs again, contact
Service.
If the display shows other alarm codes,
contact Service.
36