Operating Instructions
11
Set water softener
Using the table as a guide, adjust the water softener to that which cor-
responds to the hardness of the water in your area:
0
The dishwasher must be switched off.
Manual setting:
1.
Open the dishwasher door.
2.
Remove the lower rack from the
dishwasher.
3.
Turn the hardness range switch to 0
or 1 (see table).
4.
Replace the lower rack.
Electronic setting:
1.
Press the ON/OFF button.
The LED in the ON/OFF button will become illuminated.
3
If other indicators are also illuminated, this means that a dishwashing
cycle has been activated. The dishwashing cycle must be cancelled
(RESET):
Press function buttons
1
and
2
simultaneously for approx. 2 seconds.
All other indicators will go out.
2.
Press the function buttons
1
and
2
simultaneously and keep them
pressed.
The LED indicators in function buttons 1 to 3 will flash.
3.
Press function button
1
again.
The LED indicator for function button
1
will flash.
The multi-display will indicate the hardness setting.
4.
Pressing function button
1
increases the hardness setting by 1 degree.
(Exception: hardness setting 1 follows hardness setting 10).
5.
When the hardness setting is correct, press the ON/OFF button.
The hardness setting is now saved.
1) (°d) German degree, measure of the hardness of water
2) [mmol/l] millimol per litre, international unit for the hardness of water
3) On this setting the length of the dishwashing cycle may be slightly longer.
*) Factory setting
Summary of Contents for FAVORIT 50860 i
Page 1: ...FAVORIT 50860 i Dishwasher User Instructions ...
Page 46: ...46 ...