AEG FAVORIT 50830, User Instructions, Page: 30 / 52

Operating Instructions
30
Changing the dishwashing cycle after the start delay has been set:
As long as the dishwashing cycle has not started, you can still change
the start delay set by pressing a cycle button.
0 1. Press the button for the new dishwashing cycle and hold it down.
First the indicator for the dishwashing cycle that has just been selected
will flash.
After several seconds only the indicator for the new dishwashing cycle
will be flashing.
2. Release the cycle button.
The newly selected dishwashing cycle will start automatically following
a countdown of the hours set.
Load Sensing – Sensor Logic
If a wash programme is started even though there are only a few dishes
in the upper and/or lower rack, an intelligent electronic system adjusts
the amount of water and the duration of the wash programme to the
number of dishes. By this means it is possible to wash only a few dishes
quickly and economically. At half load (6 place settings), up to 2 litres
of water and 0.2 kWh of electricity are saved.
Switching Off the Dishwasher
Only switch the dishwasher off when the multi-display indicates "0"
remaining programme time.
0
1. Press the ON/OFF button. The ON/OFF button indicator extinguishes.
1
Hot steam may escape from the appliance when opening the door
immediately after the end of the programme. Therefore:
2. Open the door carefully.
Emptying the Dishwasher
3
• Hot dishes are sensitive to knocks. The dishes should therefore be
allowed to cool down before removing them from the appliance.
• Leave the dishes in the dishwasher for approx. 15 minutes after the
end of the programme so that they dry better and can cool down.
• First empty the lower rack, and then the upper rack. By using this
procedure you will avoid any water that may be remaining in the
upper rack, dripping onto the dishes in the lower rack and leaving
water marks.