AEG Favorit 45000, User Manual, Page: 43 / 80

• The display shows the time of the set washing programme
• The phase indicators come on.
The washing programme starts automatically.
Interruption of a washing programme
• Open the appliance door.
– The washing programme stops.
• Close the appliance door.
– The washing programme continues from the point of interruption.
Cancel the washing programme
If the washing programme has not started, you can change the selection.
To change the selection when the washing programme operates, it is necessary to cancel
the programme.
• At the same time press and hold the buttons Multitab and Delay until:
– The time of the last set washing programme flashes in the display
– The indicators of the phases of the washing programme come on.
Make sure that there is detergent in the detergent dispenser before you start a new wash -
ing programme.
End of the washing programme
The display shows a zero and the phase indicators are off when the washing programme
is completed.
1. Deactivate the appliance.
2. Open the appliance door.
3. For better drying results, keep the door ajar for some minutes.
If you do not deactivate the appliance at the end of the washing programme, the appli
-
ance stays on standby.
• To decrease energy consumption during the standby, after three minutes from the end
of the washing programme:
– All indicators go off
– The display shows one horizontal bar.
Press one of the buttons, the display and the indicators come on again.
Remove the items from the baskets
• Let the dishes become cold before you remove them from the appliance. Hot dishes
can be easily damaged.
• First remove the items from the lower basket, then from the upper basket.
• There can be water on the sides and on the door of the appliance. Stainless steel be
-
comes cool more quickly than the dishes.
Select and start a washing programme 43