24
What to do if...
Remedying small malfunctions
If while the appliance is operating indicators on the control panel flash
or are lit up as described in the following table, please consult this to
find out how to remedy the fault.
After remedying the fault that is flashing in the
first or second
rhythm
in the programme progress display, press the start-button. The
cycle will continue.
In the case of other fault messages:
–
Cancel the dishwashing cycle.
–
Switch the appliance off and on again.
–
Select dishwashing cycle.
If the fault is displayed again, please contact the Customer Care De-
partment and inform them of the fault message.
Malfunction
Possible cause
Remedy
The indicator for the end of
the dishwashing cycle is
flashing in
rhythm 1
short
light signal with approx. 3
second pause in-between:
(Problems with water inlet)
The tap is blocked or furred
with limescale.
Clean tap.
The tap is turned off.
Turn on the tap.
The filter (where present) in
the threaded hose fitting on
the tap is blocked.
Clean the filter in the
threaded hose fitting.
Filters in the base of the
washing compartment are
blocked.
Cancel the dishwashing
cycle (see section:
Starting a dishwashing
cycle);
clean filters (see section:
Cleaning the filters).
Water inlet hose
has not been correctly posi-
tioned.
Check hose installation.
The indicator for the end of
the dishwashing cycle is
flashing in
rhythm 2
short
light signals one after anoth-
er. (there is water in the
dishwasher’s internal tank).
The spigot is blocked.
Clean the spigot.
Water drain hose
has not been correctly posi-
tioned.
Check hose installation.