60
English
DAB+4158_IM
02.09.16
5. The alarm time is stored. The symbol shows in the
display.
6. Then switch the unit to standby.
Proceed as described above to set the second alarm time.
Select the menu “Alarm 2 Setup” with the / buttons.
The activated alarm will be displayed in standby mode with
the symbol “ “ for the fi rst alarm and the symbol “ “ for
the second alarm.
Turn off the alarm signal
Hold the button pressed to shut off the alarm signal. The
display shows “ALARM OFF”.
Snooze
The automatically set alarm function can be switched off for
10 minutes with the MENU / INFO / SNOOZE button. The
display shows “
“.
Deactivate alarm function
Proceed as described in the section “Setting the Alarm
Time” (step 1 to 4). Select the setting “Alarm: Alarm off”.
Confi rm with the
/ ENTER button.
AUX-IN Socket
For connecting to external players, e.g. MP3 player, smart-
phone, tablet PC etc. (Cable not included)
1. Please connect the external device with a 3.5 mm stereo
jack plug to the AUX-IN socket.
2. Use the MODE button to select AUX mode.
3. Start the playback of your audio source. You will hear the
sound playback from the external device through the
loudspeakers. You can use the
+ / –
control to adjust the
volume. The control buttons are not operational.
4. For the remaining procedure please see the operating
instructions of the external sound source.
NOTE:
Adjust the volume of the external device to a comfortable
level.
Cleaning and Maintenance
CAUTION:
Do
not
immerse the device in water.
• Always remove the mains plug before cleaning the
machine.
• Any marks on the surface can be wiped off with a slightly
damp cloth without any additives.
Troubleshooting
Problem
Cause
Solution
The unit
cannot be
operated
The unit is
blocked and
“hangs”
Disconnect the power
supply for 5 seconds.
Then switch the
device on again.
Reset the device to
the factory defaults.
see “Settings menu”
No DAB Radio
reception
Telescopic an-
tenna incorrectly
aligned
Fully extend the
telescopic antenna
and align it vertically.
No Digital Radio
can be received
in your area
Problems with
DAB radio
reception
Depending on
the location, you
may not be able
to receive some
stations at all or
with interference
in your region
.
see also note on
page 57
Switch to FM mode to
receive these stations.
If these stations are
transmitted via VHF.
Find out more on the
internet site of the
radio station.
No sound
Volume is too
low
Increase the volume
Poor sound
quality
Radio signal too
weak
Try to adjust the
antenna position.
Alarm function
does not
sound
Volume set too
low
Increase the volume
with the control (10).
No audio
signal during
bluetooth
connection.
The device is not
registered with
the audio source.
Ensure that there is a
connection. Register
the device with the
audio source again, if
necessary.
Volume too low.
Increase the volume
on the device.
Increase the volume
on the audio source.
Device can not
be connected.
Registration does
not work.
Check to see if the
audio source supports
the A2DP protocol.
Audio source is
shut off.
Turn on the audio
source.
Bluetooth is shut
off on the audio
source.
Turn on the Bluetooth
function on the audio
source.
Bluetooth version
is not supported.
Use a different play-
back device.
