Make sure that you put the glass panels
(A and B) back in the correct sequence.
Check for the symbol / printing on the
side of the glass panel, each of the glass
panels looks different to make the
disassembly and assembly easier.
When installed correctly the door trim
clicks.
A
B
Make sure that you install the middle
panel of glass in the seats correctly.
A
B
11.7
Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1.
Turn off the oven.
Wait until the oven is cooled down.
2.
Disconnect the oven from the mains.
3.
Put a cloth on the bottom of the
cavity.
CAUTION!
Always hold the halogen
lamp with a cloth to prevent
grease residue from burning
on the lamp.
The back lamp
1.
Turn the lamp glass cover to remove
it.
2.
Clean the glass cover.
3.
Replace the lamp with a suitable 300
°C heat-resistant lamp.
4.
Install the glass cover.
12.
TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
12.1
What to do if...
Problem
Possible cause
Remedy
You cannot activate or oper-
ate the oven.
The oven is not connected
to an electrical supply or it is
connected incorrectly.
Check if the oven is correctly
connected to the electrical
supply (refer to the connec-
tion diagram if available).
The oven does not heat up.
The oven is deactivated.
Activate the oven.
The oven does not heat up.
The clock is not set.
Set the clock.
The oven does not heat up.
The necessary settings are
not set.
Make sure that the settings
are correct.
www.aeg.com
26
Summary of Contents for BPS33102ZM
Page 1: ...USER MANUAL EN User Manual 2 Oven DE Benutzerinformation 32 Backofen BPS33102ZM ...
Page 65: ...DEUTSCH 65 ...
Page 66: ...www aeg com 66 ...
Page 67: ...DEUTSCH 67 ...
