6.
Press
.
When the cleaning starts, the oven door
is locked and the lamp does not work.
To stop the cleaning before it is
completed, turn off the oven.
WARNING!
After the function is
completed, the oven is very
hot. There is a risk of burns.
The door stays locked and some of the
oven functions are not available after the
cleaning is completed until temperature
in the oven decreases.
12.4
Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
The door is heavy.
1.
Open the door fully.
2.
Fully press the clamping levers (A) on
the two door hinges.
A
A
3.
Close the oven door to the first
opening position (approximately 70°
angle).
4.
Hold the door with one hand on each
side and pull it away from the oven at
an upwards angle.
5.
Put the door with the outer side
down on a soft cloth on a stable
surface.
6.
Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
1
2
B
7.
Pull the door trim to the front to
remove it.
8.
Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
9.
Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, do the
above steps in the opposite sequence.
Install the smaller panel first, then the
larger and the door.
WARNING!
Make sure that the glasses
are inserted in the correct
position otherwise the
surface of the door may
overheat.
Make sure that you put the glass panels
(C, B and A) back in the correct
sequence. First, insert panel C, which has
a square printed on the left side and a
triangle on the right side. You will also
find those symbols embossed on the
door frame. The triangle symbol on the
glass must match the triangle on the
door frame, and the square symbol must
match the square. After that insert the
other two glass panels.
www.aeg.com
42