AEG BP7004021, User Manual

Page: 35 / 44

The pyrolytic cleaning
procedure cannot start:
• if you did not remove the
core temperature sensor
plug from the socket. In
some models, the display
shows "C2" when this
error occurs.
• if you did not fully close
the oven door. In some
models, the display
shows "C3" when this
error occurs.
CAUTION!
If there are other appliances
installed in the same
cabinet, do not use them at
the same time as the
Pyrolysis function. It can
cause damage to the
appliance.
During the pyrolytic cleaning the door is
locked. The symbol and the bars of
the heat indicator come up, until the
door unlocks. The door unlocks when the
temperature inside the oven is under
safety conditions and the pyrolytic
cleaning finishes.
During the pyrolytic cleaning the lamp is
deactivated.
1. Remove the worst dirt manually.
2. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
3. Activate the appliance.
4. Set the Pyrolysis function (refer to
"Oven functions").
5. Touch or to set the duration
of the cleaning procedure:
Option Description
1 1:00 h for a
low degree of
dirt
2 1:30 h for a
usual degree
of dirt
3 2:30 h for a
high degree
of dirt
You can use the End function to
delay the start of the cleaning
procedure.
6. Touch to activate the Pyrolysis
function.
12.4 Cleaning reminder
To remind you that the pyrolytic cleaning
is necessary, the cleaning reminder
symbol
flashes in the display after
each deactivation of the appliance for
the next 10 seconds.
The cleaning reminder
goes out:
• after the end of the
pyrolytic cleaning.
• when you deactivate it in
the basic settings. Refer
to "Using the settings
menu".
12.5
Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
Be careful when you remove
the door from the appliance.
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A) on
the two door hinges.
ENGLISH 35