1.
Pull the front of the shelf support
away from the side wall.
2.
Pull the rear end of the shelf support
away from the side wall and remove
it.
1
2
Install the shelf supports in the opposite
sequence.
The retaining pins on the
telescopic runners must
point to the front.
10.4
Pyrolysis
CAUTION!
Do not start the Pyrolysis if
the Plus Steam button is
pressed in.
CAUTION!
Remove all accessories and
removable shelf supports.
Do not start the Pyrolysis if
you did not fully close the
oven door. In some models,
the display shows "C3"
when this error occurs.
WARNING!
The appliance becomes very
hot. There is a risk of burns.
CAUTION!
If there are other appliances
installed in the same
cabinet, do not use them
when the Pyrolysis function
operates. It can cause
damage to the appliance.
1.
Remove the worst dirt manually.
2.
Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
3.
Set the Pyrolysis function. Refer to
"Oven functions".
4.
When
flashes, press or to
set the necessary procedure:
Option
Description
P1
If the oven is
not very dirty.
Time of the
procedure: 1
h 30 min.
P2
If you cannot
easily remove
the dirt. Time
of the proce-
dure: 2 h 30
min.
You can use the End function to delay
the start of the cleaning procedure.
During the Pyrolysis the oven lamp is off.
5.
To change the default length of the
procedure (
P1
or
P2
), press to set
, and then press or to set
the length of the cleaning procedure.
6.
When the oven is at its set
temperature, the door locks. The
display shows the symbol and the
bars of the heat indicator until the
door unlocks.
7.
When Pyrolysis is completed, the
display shows the time of day. The
oven door stays locked.
8.
When the appliance is cool again, an
acoustic signal sounds and the door
unlocks.
www.aeg.com
30
Summary of Contents for BP301350
Page 1: ...EN User Manual Oven BP301350 BP301352 ...
Page 37: ...ENGLISH 37 ...
Page 38: ...www aeg com 38 ...
Page 39: ...ENGLISH 39 ...