CAUTION!
To carry out the following
operations, we suggest that
this be made with another
person that will keep a firm
hold on the doors of the
appliance during the
operations.
1.
Tilt back the appliance carefully so
that the compressor cannot touch
the floor.
2.
Unscrew both adjustable feet.
3.
Unscrew the screws of the door
bottom hinge.
4.
Take off the appliance door by
pulling it slightly downwards.
5.
Unscrew the top door hinge pin of
the appliance then screw it back on
the other side.
2
1
6.
Fit the appliance door on the upper
door hinge pin.
7.
Remove the lower hinge. Put over
the pin in the direction of the arrow.
8.
Unscrew and install the screw on the
opposite side.
9.
Install the lower hinge on the
opposite side leaving the position of
the door unchanged.
10.
Screw in the one screw in the place
set free on the other side as well as
the adjustable feet (2 pieces).
11.
Remove and install the handle on the
opposite side.
1
2
3
4
CAUTION!
Reposition, level the
appliance, wait for at least
four hours and then connect
it to the power socket.
Do a final check to make
sure that:
• All screws are tightened.
• The magnetic seal
adheres to the cabinet.
• The door opens and
closes correctly.
If the ambient temperature
is cold (i.e. in Winter), the
gasket may not fit perfectly
to the cabinet. In that case,
wait for the natural fitting of
the gasket.
In case you do not want to
carry out the above
mentioned operations,
contact the nearest
Authorised Service Centre.
The Authorised Service
specialist will carry out the
reversibility of the doors at
your cost.
8.5
Electrical connection
• Before plugging in, ensure that the
voltage and frequency shown on the
rating plate correspond to your
domestic power supply.
www.aeg.com
14
