10
Operation
AHo 40 MTH
With the twin-handle tap, you draw hot water by turning
the right handle. You can draw cold water by turning the
left handle only.
If you turn both handles you can mix the required tem-
perature by opening and closing off the water flow as
appropriate.
5.
Cleaning, care and
maintenance
Clean the taps with a damp cloth. Never use abrasive or
corrosive cleaning agents.
Descale the jet controller if it is clogged with limescale.
Remove it from the pivoting spout to do this.
6.
What to do if ...
6.1
... there is no hot water
Although the draw-off valve is fully opened. In this case, it
could be that the small instantaneous water heater has not
heated the water because there is no power. Check the
MCB/fuse and residual current device in your fuse box.
6.2
... the water flow rate is weak
It could be that the jet controller in the tap is contamina-
ted or scaled up. In this case clean the jet controller or
descale it. You can order the jet controller from us as a
spare part:
◦
AHEu 40 MTH part number 254568
◦
AHEu 40 MTH / AHEu 40 MTH part number 254574
7.
Safety
7.1
Country-specific safety information
All required steps up to and including commissioning must
be carried out by a qualified contractor. During this pro
-
cess, these installation instructions must be observed.
We guarantee trouble-free function and operational re-
liability only if the original accessories and spare parts
intended for the tap are used.
7.2
Instructions, standards and regulations
!
Observe all applicable national and local instruc
-
tions and regulations, e.g. DIN 1988 and EN 806 in
Germany.
8.
Equipment description
With the AHo 40 MTH twin-handle wall mounted tap for
small open vented (unpressurised) instantaneous water
heaters, the handles are arranged in the opposite way
to those of mains pressure taps, in accordance with
DIN 44897 T1:
◦
cold water (blue) left and
◦
hot water (red) right.
8.1
Standard delivery
The following diagrams show the standard delivery. The
pipes connected to the AHo 40 MTH tap are chrome-pla-
ted copper pipes. The connection hoses for the AHEu 40
MTH / AHu 40 MTH are made of plastic with a stainless
steel mesh.
AHEu 40 MTH
5
6
11.4
1
2 3
SW 22
12
7
4
8
9
10
13
11.2
11.3
11.1
11
(SW 13)
26
_0
2_
10
_00
85
1 Lever
2 Outlet
3 Special jet controller
4 CW connection hose - blue
5
Connection hose (⅜) - blue
6
Connection hose (⅜) - red
7 Seal ring
8
U-shaped profile washer
9 U-shaped pressure washer
10 Adaptor sleeve (SW 13)
11 Waste set
11.1
Drain fitting
11.2 Gasket
11.3
Profile gasket
11.4
Drain outlet
12 Pull rod
13 Knuckle joint
Summary of Contents for AHEu 40 MTH
Page 19: ...19 Notatki ...
