AEG AGE62526NW, User Manual

Page: 8 / 16

If "dEMo" appears on the display, refer
to "Troubleshooting" chapter.
4.3 Switching off
1. Press ON/OFF for a few seconds.
The display switches off.
2.
Disconnect the mains plug from the
power socket.
4.4 Temperature regulation
The set temperature of the freezer may
be adjusted by pressing the temperature
button.
Default temperature:
• -18°C for the freezer
The temperature indicator shows the set
temperature.
The set temperature will be
reached within 24 hours.
After a power failure the set
temperature remains stored.
4.5
High temperature alarm
An increase in the temperature in the
freezer compartment (for example due to
an earlier power failure) is indicated by:
• flashing of the alarm and freezer
temperature indicators;
• sounding of the buzzer.
Press any button to reset the alarm.
The buzzer switches off.
The freezer temperature indicator shows
the highest temperature reached for a
few seconds. Then show again the set
temperature.
The alarm indicator continues to flash
until the normal conditions are restored.
4.6 FROSTMATIC function
This function accelerates the freezing of
fresh food and protects food products
already stored from warming.
1. Press Mode button repeatedly until
FROSTMATIC icon flashes.
2. Press OK button to confirm your
selection.
The FROSTMATIC indicator is displayed.
This function deactivates
automatically after 52 hours.
To switch off the function
before its automatic end,
repeat the steps until the
FROSTMATIC indicator
disappears.
4.7
Door open alarm
If the door is left open for approximately
90 seconds, the acoustic alarm starts and
alarm indicator flashes.
The alarm stops after closing the door.
During the alarm, the acoustic signal can
be muted by pressing any button.
4.8
DrinksChill function
Use this function to set an acoustic alarm
at the preferred time for example when a
recipe requires to cool down food
products for a certain length of time.
It is also useful when a reminder is
needed not to forget the bottles placed
in the freezer for fast cooling.
1. Press Mode until the corresponding
icon appears.
The DrinksChill indicator flashes.
The Timer shows the set value (30
minutes) for a few seconds.
2. Press the Temperature colder or
Temperature warmer button to
change the Timer set value from 1 to
90 minutes.
3. Press OK to confirm.
The DrinksChill indicator is displayed.
The Timer starts to flash (min).
It is possible to change the time at any
time during the countdown and at the
end by pressing the Temperature colder
button and the Temperature warmer
button.
At the end of the countdown, the
DrinksChill indicator flashes and an alarm
sounds. Press OK to switch off the sound
and deactivate the function.
It is possible to deactivate the function at
any time during the countdown by
repeating the function steps, until the
indicator disappears.
www.aeg.com 8